MSD Tech Support Forums

Go Back   MSD Tech Support Forums > MSD Ignition Forums > Applications

Applications Which ignition is right for your vehicle.

Thread Tools
Old 01-12-2004, 03:06 PM
Posts: n/a

I have just purchased a MSD 6AL box that I shall mount in my old Beetle.
I run with Pertronix flame thrower coil, I couldn't find it in the coil
compatibility list, so I asked "MSD" if it is it OK to use?
the answer was that as long as the primary resistance from the plus and minus of the coil is under 1.5 ohms it will work great.
My coil is 3ohm, what do I do? Do I have to bye a new one or can I fix it some way?

with best regards
Reply With Quote
Old 01-12-2004, 05:10 PM
Posts: n/a


Unfortunately if your coil has an excessive amount of resistance it cannot be fixed and must be replaced with a lower resistance coil.

Msdtech 13
Reply With Quote


Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Problems With My Coil... MuttandSolo Trouble-Shooting 4 07-18-2005 07:46 AM
Blaster Ss Coil Cause Pcm Coil Driver Failure? stsurbrook Trouble-Shooting 2 05-12-2004 08:20 AM
Gas Savings///bad Running System bigal Trouble-Shooting 6 03-26-2004 12:50 PM
Big 6a/blaster Ss Problems spy88 Trouble-Shooting 5 03-26-2004 12:11 PM
Blaster Coil On 1968 Ford 302 Wildcat Trouble-Shooting 5 11-05-2003 10:40 AM

All times are GMT -6. The time now is 07:01 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2016, vBulletin Solutions, Inc.
2016 MSD Performance