MSD Tech Support Forums

Go Back   MSD Tech Support Forums > MSD Ignition Forums > Trouble-Shooting

Trouble-Shooting Diagnose your ignition

Thread Tools
Old 09-20-2012, 08:01 PM
rockin jester
Posts: n/a
Default Hvc-2 ?

Is it necessary to install a chassis ground from the negative side of the HVC-2 coil? Reason for asking is... I just installed a MSD 7531 and Holley Dominator ECU with crank sensor and hall effect cam sync. I have no spark to the distributor. I disconnected the white wire from the ECU and 7531, and the coil boot from the distributor. When I grounded the white wire I did have spark to the coil boot. In the wiring diagram from Holley it shows a separate ground wire coming from the negative side of the coil to the chassis ground. I did not notice until now while reviewing the diagram. but I did not run a separate ground to the coil. All that is hooked up is the orange and black wires going to the 7531. FYI. The way it is wired I am using the ECU to control the timing and the 7531 to deliver it.
Reply With Quote
Old 09-21-2012, 03:14 AM
rockin jester
Posts: n/a

70 views and not 1 reply..... Amazing
Reply With Quote
Old 09-24-2012, 09:00 AM
msdtech1955's Avatar
msdtech1955 msdtech1955 is offline
Senior Member
Join Date: Jan 2008
Posts: 10,289

it is always best to have a good clean ground path.
like this example.

Reply With Quote


Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -6. The time now is 11:48 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2016, vBulletin Solutions, Inc.
2016 MSD Performance