MSD Tech Support Forums

Go Back   MSD Tech Support Forums > MSD Ignition Forums > Installation Questions

Installation Questions Wiring and Tech Information

Thread Tools
Old 04-09-2012, 11:47 AM
dcwinters dcwinters is offline
Junior Member
Join Date: Feb 2008
Posts: 10
Default Blaster coil install on 1998 boat

I suspect my original coil on 350 V8 OMC stern drive boat is weak. I am replacing it with a Blaster 2 coil.

The stock igintion has a electrionic ignition model loacted in the distribitor. The stock coil has an external resistor.

Can I just use the exiting resistor, or do i also need to add the MSD 8214 Ballast resistor in series to the existing resistor? The exiting coil has a resistance of 2.1 ohms and I getting 1.3 ohms from the Blaster. So it looks like I need to add the .8 MSD resistor.

Just don't want to hurt the stock electronic ignition. Would it hurt to add the .8 ballast anyway?
Reply With Quote
Old 04-10-2012, 08:59 AM
Posts: n/a

if those are the readings you are getting then YES you should be using that .8 ohm resistor.
Reply With Quote


Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -6. The time now is 12:06 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2016, vBulletin Solutions, Inc.
2016 MSD Performance