Results 1 to 2 of 2

Thread: New install on rebuilt 406sbc

  1. #1
    Join Date
    Jul 2017

    Smile New install on rebuilt 406sbc

    I had my 406 rebuilt and decided it was time to jump into fuel injection on a 1972 Chevy K10. I installed a Boyd's Welding tank under the bed. I bought the master kit with the return kit. I ran into a few issues. Fuel system was super easy to run. I have had no leaks to date. My fuel pump is frame mounted about 4 feet from the tank but with the return system I have had no issues. I did wrap the exhaust in heat tape to keep the worst radiant heat from the pump. I figure I'll use it until it dies and get an in-tank pump. I was disappointed that there is no kit to allow you to drop the pump in the tank. The instructions all say you need a wiring harness and fuel sock but I couldn't find one. Seams like a great idea to me...

    I am running a MSD 6A and a Pro-Billet distributor. I wanted the system to run the timing. I got it hooked up correctly but didn't read the instructions close enough. I set the Initial screen to disable timing and when I would enable it, the engine would die. I put in the rotor phasing cap not realizing that there was 20 degrees possible and I reset it to 15. The trick was to enable the timing in the initial screen, lock it in the advance screen to set the timing at -15. These two points are different. It made sense to me that -15 with timing disabled and -15 locked out would be the same place, but it isn't. As soon as I figured that out,(it was clear in the instructions) my engine is happy to run.

    I am hoping that this will turn my truck into a reliable runner for the winters here in Montana. image1.jpeg

  2. #2


    good to hear.

    it has been a few years since my install. i have the atomic controlling my timing also. i forgot how to set it up but will bookmark your post for future reference.

    i havent needed to mess with the atomic in a long time. its been running well.

Tags for this Thread


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts